Brother gt 541 remove top tube
(15) Pull out the Pump Tube from the top left of the Tube Pump while rotating the Rotate Gear in the direction of CW by hand. The cap draining test for the Brother GT-541 direct-to-garment (DTG) printer will help determine if the drain tubes below the print head caps are properly. (14) Connect the Pump Tube on the top right of the Tube Pump with the L-shaped Tube Fitting on the Solenoid Unit, and then bind the elementary part with the KI Tie. (13) Fasten the two screws to fix the Tube Pump Rotor. (12) Slide the Tube Pump Rotor back into the Tube Pump Housing, and push down the Tube Pump Rotor until it clicks. (11) Apply the grease MOLYKOTE EM30-L (S58541000) lightly on the new Pump Tube.
(Be careful of the direction to route the Pump Tube. One Tube Cleaning Bottle for GT-381, GT-361. (10) Fit the new Pump Tube in the U-shaped guide groove. Do not turn off your printer, or open the Front Cover during the. (You do not have to disconnect the Print Heads. (2) Move the Carriage to the Print Head Cap position by hand. Otherwise it will interrupt the setting of the MNT Check Gauge. (9) Turn over the Tube Pump Rotor and remove the Pump Tube. GT-541 164 (1) Remove the fixing screw on the top left of the Frame FR, and then move the Wiper Cleaner Detecting Switch to the side temporarily. (8) Slide the Tube Pump Rotor upward to remove it. (7) Remove the two screws (M3 x 35)that fix the Tube Pump Rotor. (6) Disconnect the Pump Tube from the L-shaped Fitting. (5) Cut the KI Tie with a nipper and then remove it. (4) Pull out the L-shaped Tube Fitting unit on the. Removing the Covers' for details.) (3) Disconnect the Pump TUbe on the top left of the Tube Pump connected with the Drain Plug. Replacing the Tube Pump Tubes of the Maintenance Unit. Seasoned cutters will appreciate how the handle reduces stress on the wrist and arm, and everyone from beginners to advanced cutters love the 'track and guide. Replacing the Tube Pump on the Brother GT-541. Drain tubes become impacted at the solenoid pinch spot deep inside the Maintenance Station with dried ink residue and lint or dust that is flushed past Caps. There is enough solution to clear/flush all 4 drain tubes. (4) Pull out the L-shaped Tube Fitting unit on the top right of the Tube Pump. The My Comfort Cutter is the top of the line ergonomic rotary cutter from TrueCUT It's comfort curve grip is especially designed to make rotary cutting easier, safer and more accurate. Suggested Use: Use this kit for clearing clogged drain tubes in the BrotherĀ® GT-541 or GT-782 direct to garment inkjet printers. (3) Disconnect the Pump TUbe on the top left of the Tube Pump connected with the Drain Plug. Replacing the Tube Pump Tubes of the Maintenance Unit